Positive Cable Connector To Shunt Box

[205007 12]

i am just finishing the wiring off to the rally car and i have used the positive cable from a ph1 car

 

the rest of the loom is ph2

 

is this connector on 1st pic the same on all models or does it differ on phase?

 

also on the 2nd pic im pretty sure the small plug goes to the fan speed resistor, but it only has 2 wires in, the resistor has 3 prongs on the plug? is this right?

 

cheers

 

adam

 

ps the light blue wire is this for the horn?

Edited March 25, 2007 by 205007

[pug_ham 240 3 Cars]

Adam,

 

I'm pretty sure they differ.

 

I stripped a phase 1 309 & that had the same kind of shunt box as you have pictured where the phase 2 ones are connected to the battery by two ring terminals that fit to studs on one end.

 

The fan plug in your second picture connects into the fan loom which is seperate & plugs into the shunt box iirc.

 

I think I have a spare phase 1.5 loom for this downstairs which needs a repair to one wire.

 

Graham.

[Miles 331 1 Cars]

Agree with Graham that's a 309 cable

[205007 12]

After deliberation and looking at several 205`s for future refrence

 

Phase 1 cars dont have a shunt box they have separate connections to route positive power from the batery

 

the cable in 1st pic is from a phase 1 205 gti

 

All i needed to do was remove the plastic covers on the positive cables shown and attach to phase 2 shunt box to provide juice to the shunt

 

the second picture shows 2 connectors:

 

the large connector goes to the shunt

the small connector goes to the fan speed relay

 

still not worked the blue one out!

[Miles 331 1 Cars]

ps the light blue wire is this for the horn, it is

The brown plug doesn't go to the fan, It should be for the dim dip circuit, I'll check this out tomorrow if I remember