Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
Martin W

Heater Matrix

Recommended Posts

Martin W

I've removed the heater and matrix etc from inside the car and now I have the hole over the bulkhead that I need to block off.

 

How have other people covered this?

 

I was thinking of a thick piece of plastic and a large jubilee clip to cover/seal it. Is there a better way?

 

Thanks, Martin.

Share this post


Link to post
Share on other sites
smighall

Ah good point, i've just removed mine too and hadn't thought that far yet lol

Share this post


Link to post
Share on other sites
Martin W
Ah good point, i've just removed mine too and hadn't thought that far yet lol

I've just got the heater 'hole' and sunroof 'hole' to fill now. Sunroof is easy with a sheet of ali.

 

I just want it to be properly water tight as the hole left from removing the heater is right above the fuse box!

Share this post


Link to post
Share on other sites
welshpug

for quite a while I thought you mean where the hoses go through the bulkhead Martin :)

 

bit of ally and silicone sealant do the trick?

Share this post


Link to post
Share on other sites
jonnie205

ally sheet and some panel bond or rivit

Share this post


Link to post
Share on other sites
Miles

Yep, I just used a thin sheet of steel, Bolt's and some RTV. Never leaked in the 6 yr's I had it

Share this post


Link to post
Share on other sites
Martin W
Yep, I just used a thin sheet of steel, Bolt's and some RTV. Never leaked in the 6 yr's I had it

Thanks everyone, a sheet of ally and some panel bond it will be (plus bolts if needed).

Share this post


Link to post
Share on other sites
Sign in to follow this  

×