Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
jdman

Gti6 Coversion Pressure Sender Question

Recommended Posts

jdman

Hi Im in the middle of a gti6 conversion but into a 309 but most of the wires are the same 30b is the oil pressure sender from the 309 loom. I have an issue do i take the origional wire 30b from the dash and bring it to a new 205 gti pressure sender i have added to the block. if yes what voltage should i see in the wire 30b.

 

thanks in advance.

Share this post


Link to post
Share on other sites
Thijs_Rallye

12V unconnected normally. Same for the oil temp, oil pressure switch etc.

Share this post


Link to post
Share on other sites
jdman

12V unconnected normally. Same for the oil temp, oil pressure switch etc.

 

 

thanks i have less than 1v so i was wondering if my dash is faulty

Share this post


Link to post
Share on other sites
Thijs_Rallye

Measure again at the brown multiplug. Usually they are corroded very badly.

Share this post


Link to post
Share on other sites
jdman

Measure again at the brown multiplug. Usually they are corroded very badly.

 

i measured at the plug still less than a volt not sure what to test next

Share this post


Link to post
Share on other sites
welshpug

work backwards in the circuit till you find the cause.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×