Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
selfyyy

Rear Beam Mounts

Recommended Posts

selfyyy

Has anyone got the dimensions for the rear beam mounts, want to have some made but removing the beam to measure them makes the care immobile.

Cheers

  • Like 1

Share this post


Link to post
Share on other sites
petert

Ø50 x 50 long.

Share this post


Link to post
Share on other sites
dcc

Which mounts

Share this post


Link to post
Share on other sites
petert

I've made a few sets and you really need to know what you're doing, in order to get the tolerances correct. Additionally, the front bushes in your pic aren't very good as they don't have a crush tube. Without they'll flog out prematurely. You'll never get the front bushes out without damaging them. As I said earlier, the rear blocks are easy. Just drill a Ø10.5mm hole through some Ø50 bar. The original blocks are offset but that's unnecessary.

 

I think I used Sustamid for the front bushes.

post-2864-0-55087800-1500370338.jpg

post-2864-0-44075200-1500370351.jpg

post-2864-0-20739300-1500370373.jpg

Edited by petert

Share this post


Link to post
Share on other sites
Tom Fenton

I've made upteen sets. If you can use a lathe you can make these, there is nothing complicated about them. I use Acetal usually.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×