5176 17 Arm shaft is quite self explanatory in description
5148 48 Crossmember tube I haven't actually taken a decent a picture of, what is good to know here is that they come with all 4 bearings prefitted, saving you about £30
5172 24 Bearing bush is for the Anti Roll bar end plate.
5174 03 Crossmember seal, this sits between the ARB plate and the end of the arm shaft.
both shown here -
5131 45 Socket, is the bearing, as is 5132 49 (inner + outer)
5154 09 CUP is the part that sits on the arm shaft, which the seal runs on
5154 08 Suspension Arm Seal, guess what!! this is the part that lets all the crap into your beam!!
5154 10 is the metal sleeve that the seal is pressed into.
finally the little screws etc in the attached pictures;
5153 10 Suspension bar Stud, this is the stud that had a shoulder half way and a slotted end.
5153 12 Suspension Bar Washer, this is the offset washer on the end of the anti roll bar.
5154 05 Plug, this sits on the opposite end to the offset washer, and has the shouldered stud poking through it.
it can be seen at the top of this picture of a fooked beam tube
5153 11 Crossmember screw, this is the Torx headed countersunk bolt that everyone has difficulty with.
6932 38 Nut, this is the locknut for the Shouldered stud.
hope this is helpful to all those needing the parts.