205 16v Drive Problems Easy If Someone Nose What Shafts To Use

[205johnnyxsi 0]

Hello having a few problems

 

We got a 205 xl with a gti from a 106 in her

 

Gearbox is off a quicksilver

 

hubs are off a 309

 

and driveshaft is from a 106 gti

 

We no the problem its the drive shaft but what drive shafts are to be used as we tried gti one are we to use 1.1`s? or 205 gti shafts please could somebody let us no what drive shafts we are serpose to use due to the last owner being un sure what the car was running on

 

thanks johnny

[205johnnyxsi 0]

Anyone ?

[bren_1.3 1]

going to have to be a bit more specific here..

 

what exactly is the problem with the driveshafts? they dont fit? its broken? what?

 

box is off a quicksilver? whats a quicksilver? MA type? BE type?

 

hubs off a 309 gti? a base model 309?

 

cant really give any answers until this starts to make sense...as its a bit gobbledegoog at the moment.

[drmo 5]

The problem probably is that the driveshafts are too long/short. In your case the best suiting shafts would be that of an xl

[Richie-Van-GTi 70 2 Cars]

If your using 309 gti hubs then chances are the spline size is too big for most of your TU shafts as well. You'll either have to find outer XU cv pots that fit onto correct length shafts or swap to smaller size hubs from a TU 309 or N/A derv to get the smaller spline size.