Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
B1ack_Mi16

Xu10J2Te 2.0 8V Turbo Map Sensor Spec?

Recommended Posts

B1ack_Mi16

I'm butchering a 2.0 8v turbo ECU to use the housing for my megasquirt 3 pro module.

 

I want to use the built-in map sensor on the 2.0 8v ECU as a barosensor in my new setup.

 

Bosch number is:1267632015

 

And I can't seem to find any data sheet on it to give me the relation between voltage and pressure.

 

Anyone able to help out?

 

IMG_20151024_105900_zpsaycfk0d4.jpg

Edited by B1ack_Mi16

Share this post


Link to post
Share on other sites
welshpug

will that unit go high enough for your engine? iirc its been mentioned they are a 2 bar absolute, I.e 1 bar boost max.

Share this post


Link to post
Share on other sites
Tom Fenton

200kpa is 2bar or near enough,

 

Assuming you feed it 0v and +5v;

 

1 bar vac will be 0v

Atmo will be +2.5v or near to it

1 bar boost +5v

 

Easy enough to rig up and test to be sure.

Share this post


Link to post
Share on other sites
B1ack_Mi16

Know I could start measuring it, however I would need a realiable pressure source etc.

So would ideally prefer a datasheet, though it proves a bit hard to find.

 

Welsh: I have a 3 bar MAP sensor, this is only to be installed as a barosensor, correcting for enviromental air pressure.

Share this post


Link to post
Share on other sites
B1ack_Mi16

Found this for some similar sensors though.

 

2015-10-28%2014_02_12-www.farnell.com_da

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×